My DIY rock sliders

Quote:

---

Originally Posted by V8Landy

Great job Boxer. I have had the material for a while to do mine but the bend in the sill was stopping me(no talent). How did you bend the bar. I was thinking of putting the box section(75x50) on its 75mm side on a peice of timber at one end the driving on it. Not sure how this would go though. I dont have access to a oxy. Cheers Brett:)

---

I didn't know you had to bend it?

Quote:

---

Originally Posted by 4wd4fun

Was looking at that would not be hard to tap back with an adjustment hammer.:twisted:

---

It's cred, I'm leaving it :)

Quote:

---

Originally Posted by V8Landy

Great job Boxer. I have had the material for a while to do mine but the bend in the sill was stopping me(no talent). How did you bend the bar. I was thinking of putting the box section(75x50) on its 75mm side on a peice of timber at one end the driving on it. Not sure how this would go though. I dont have access to a oxy. Cheers Brett:)

---

http://www.aulro.com/afvb/technical-...thwhile-3.html

look in the last post, about using a hack saw blade..

Interesting design Mark. Ill be doing mine the way I did the old RRC of mine. Basically box section UNDER the sill itself, with two plates running up either side of the sill (also acts like a crush protector so wont crush stills when tighening). Then add the side rails like you did for lower door protection.

With your type of driving (if stunting is anything to go by) you should have gone full on rock sliders :D :cool:

Quote:

---

Originally Posted by stooge

Interesting design Mark. Ill be doing mine the way I did the old RRC of mine. Basically box section UNDER the sill itself, with two plates running up either side of the sill (also acts like a crush protector so wont crush stills when tighening). Then add the side rails like you did for lower door protection.

With your type of driving (if stunting is anything to go by) you should have gone full on rock sliders :D :cool:

---

I thought about doing mine that way, but ground clearance is my game :)

Good looking job fella

wELL DONE THEY LOOK GREAT iD LOVE SOME ON MY dISCO ,bravo
MAYBE YOU COULD DRAW UP SOME PLANS ................Great Job!

Mark , what did you end up using , 75mm x 50 mm RHS ? was it 3mm plate or 4mm plate you used for the top part ?

Used 505 x 50 on mine, but the other sets were 75 x 50 and 3mm plate. Also gave the 75mm ones a curve to follow the doors, mine were simple.

Black Betty's ones are here

http://www.aulro.com/afvb/discovery-...y-sliders.html

My Rock Sliders are the cheapest and lightest on the market. No installation required.


..https://www.aulro.com/afvb/images/im...009/10/583.jpg