Hi folks,

Just refitted my front weight thingy to the steering stabiliser axle housing bracket.

I was at the wreckers looking for other bits and pieces and figured I would remount the weight thingy that has been off since I needed the mount during Easter last year. If nothing else it is a good place to store a mount.

Anyway my weight and bracket have 10mm holes however my new found mount has 12mm studs. Which means there must be 10mm stud engine mounts and 12mm stud engine mounts available.

I checked the gearbox mounts and they are 10mm (one genuine & one aftermarket) however they have 12mm holes/slots.
I have QT engine mounts so didn't check them.

Interesting.

I just drilled my weight and bracket to 12mm and fitted it.

Should add that mine is a 1994 update model and the mount was taken off a 1997/98 model.