Thread: D2 Spring Lift

Hope these pictures show you what you want. Tyres are slightly bigger than std, 245/75/16. Pre-lift pic was with rear std height spring conversion from SLS.

Pre lift

Pic_0827_011.jpg


Post lift

2in lift.jpg

For the SLS light, you need to find someone with a computer to turn off this function.

Gags

There is a post in one of the "lift' threads that tells the normal height of the top of the wheel arch when measured 'through' the centre of the wheel.

I apologise I don't have it bookmarked and that it is too late for me to search for it.

Its 840 at the back to the top of the arch and 800ish at the front.

Tyres are 235/70R16s.

Will go searching for the threads you mentioned. Thanks.

The standard heights are as follows

FRONT
Nominal height from hub centre to wheel arch (not liner)

500 ± 15 mm (19.7 ± 0.6 in)


REAR
Nominal height from hub centre to wheel arch (not liner)

Coil spring 483 ± 15 mm (19.0 ± 0.6 in)
Air spring 473 ± 15 mm (18.6 ± 0.6 in)

Originally Posted by Urban Panzer

The standard heights are as follows

FRONT
Nominal height from hub centre to wheel arch (not liner)

500 ± 15 mm (19.7 ± 0.6 in)


REAR
Nominal height from hub centre to wheel arch (not liner)

Coil spring 483 ± 15 mm (19.0 ± 0.6 in)
Air spring 473 ± 15 mm (18.6 ± 0.6 in)

Like the man said...


Thanks UP!

Originally Posted by Urban Panzer

The standard heights are as follows

FRONT
Nominal height from hub centre to wheel arch (not liner)

500 ± 15 mm (19.7 ± 0.6 in)


REAR
Nominal height from hub centre to wheel arch (not liner)

Coil spring 483 ± 15 mm (19.0 ± 0.6 in)
Air spring 473 ± 15 mm (18.6 ± 0.6 in)

What does (not liner) mean? Is that the plastic on the arch? Will do some more measurements.

James

Originally Posted by JBM*

What does (not liner) mean? Is that the plastic on the arch? Will do some more measurements.

James

NOT the plastic in the wheen arch - the exterior metal immediately above the cetre of the hub.

Whats the height of a lifted D2 center of wheel to fender.???