Thread: Won't sit level

could it be something simple like a faulty dash switch or wiring that gets triggered when brakeing? When you are trying to lower it again are all the doors closed with engine running?
Dylan

Thanks for the quick response I thought about the switch but the dash light doesn't come on and it's staying up .

Was it sitting ok and system fine before doing the front?

Have you lifted the front?
If so, what have you done to raise the rear?

If it has been raised and you havnt put in longer bags or spacers , this will likely be a major part of the problem.

Did your mech touch the sensor arms or were his adjustments made solely by the scan tool?

Under many braking conditions the sensors will release air from the bags (tail up from the deceleration) and when the vehicle stops it will be sensing slightly low therfore the compressor will start to bring it back back to level.

If all standard and no touching of sensor arms, I suggest you check the compressor relay. Sounds like it is not shutting off (full height inflation) and then timing out (chimes).

cheers