Page 1 of 3 123 LastLast
Results 1 to 10 of 25

Thread: ARB Locker Switch Positions ??

  1. 29th December 2011, 07:18 PM #1
    Mr.Bear's Avatar
    Mr.Bear
    Mr.Bear is offline Master
    Join Date
    Aug 2010
    Location
    Inner West Sydney Australia
    Posts
    166
    Total Downloaded
    0

    ARB Locker Switch Positions ??

    Hi Im about to get ARB to install a rear diff lock. They were a bit vague about positioning the two switches.
    I have to say the Landy dash layout doesnt lend itself to fitting accessories
    Anyone got any advice or photo's
    Reply With Quote Reply With Quote
  2. 29th December 2011, 07:46 PM #2
    Slunnie's Avatar
    Slunnie
    Slunnie is offline Swaggie Gold Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    14,147
    Total Downloaded
    99.87 MB
    Mine are on a panel on the overhead console. Works well there.
    Cheers
    Slunnie


    ~ Discovery II Td5 ~ Discovery 3dr V8 ~ Series IIa 6cyl ute ~ Series II V8 ute ~
    Reply With Quote Reply With Quote
  3. 29th December 2011, 08:55 PM #3
    It'sNotWorthComplaining! Guest
    You could put them in the spot in the blanking plate of where the sunroof switches would go. Just means you have to reach up to activate. It'll give the Disco that aircraft cock pit feel.
    Reply With Quote Reply With Quote
  4. 29th December 2011, 11:47 PM #4
    rangieman's Avatar
    rangieman
    rangieman is offline Swaggie
    Join Date
    Jan 1970
    Location
    Free Again Thanks Dan
    Posts
    10,150
    Total Downloaded
    0
    Quote Originally Posted by It'sNotWorthComplaining! View Post
    You could put them in the spot in the blanking plate of where the sunroof switches would go. Just means you have to reach up to activate. It'll give the Disco that aircraft cock pit feel.
    Thats where all 3 of my switch,s live
    Reply With Quote Reply With Quote
  5. 30th December 2011, 12:09 AM #5
    twodoors
    twodoors is offline Master
    Join Date
    Nov 2009
    Location
    Ceduna, SA
    Posts
    254
    Total Downloaded
    0
    Just get the arb 3 switch holder and fit it in the cigarette / coin holder on the dash.... Easy fit and easy to run the wires to.... Send me a mobile number and i will mms a few pics... Cant post pics from this phone... Or check out my earlier posts on my air compressor or cup holders n u can c the pics there.... So simple to do.. James
    Reply With Quote Reply With Quote
  6. 30th December 2011, 08:04 PM #6
    Mr.Bear's Avatar
    Mr.Bear
    Mr.Bear is offline Master
    Join Date
    Aug 2010
    Location
    Inner West Sydney Australia
    Posts
    166
    Total Downloaded
    0
    Quote Originally Posted by twodoors View Post
    Just get the arb 3 switch holder and fit it in the cigarette / coin holder on the dash.... Easy fit and easy to run the wires to.... James
    Thanks James, Where did you buy the 3 switch holder? I searched ARBs website and price catalogue but didnt see them in either? I found one on ebay USA not sure if its the same though, cheers, mrbear
    Reply With Quote Reply With Quote
  7. 30th December 2011, 08:06 PM #7
    Mr.Bear's Avatar
    Mr.Bear
    Mr.Bear is offline Master
    Join Date
    Aug 2010
    Location
    Inner West Sydney Australia
    Posts
    166
    Total Downloaded
    0
    Quote Originally Posted by It'sNotWorthComplaining! View Post
    You could put them in the spot in the blanking plate of where the sunroof switches would go. Just means you have to reach up to activate. It'll give the Disco that aircraft cock pit feel.
    Its a good spot, but annoyingly my CB is already there, cheers, mrbear
    Reply With Quote Reply With Quote
  8. 30th December 2011, 09:17 PM #8
    JGARDE's Avatar
    JGARDE
    JGARDE is offline Fossicker
    Join Date
    Nov 2011
    Location
    perth
    Posts
    51
    Total Downloaded
    0
    You could put them inbetween the window switches if you dont have heated seats i am going putting mine there when i get the chance
    Reply With Quote Reply With Quote
  9. 30th December 2011, 09:59 PM #9
    Tank's Avatar
    Tank
    Tank is offline AT REST
    Join Date
    Jan 1970
    Location
    Moruya Heads/Sth. Coast, NSW
    Posts
    6,532
    Total Downloaded
    0
    Mine are in the panel that hides the fuses, right by the steering column, Regards Frank.
    Reply With Quote Reply With Quote
  10. 31st December 2011, 12:20 AM #10
    twodoors
    twodoors is offline Master
    Join Date
    Nov 2009
    Location
    Ceduna, SA
    Posts
    254
    Total Downloaded
    0
    Quote Originally Posted by MRBEAR View Post
    Thanks James, Where did you buy the 3 switch holder? I searched ARBs website and price catalogue but didnt see them in either? I found one on ebay USA not sure if its the same though, cheers, mrbear
    When i went into arb adelaide to see which rocker switch covers they had the chap at the counter asked if i had a switchplate... They come in 2 or 3 switch options... Dont know part number but if you phone they will know.. Genuine arb stock not a buy in... Switches sit just perfectly.... But the led back light aint half bright!!!.. Again why i wanted them mounted low....
    Reply With Quote Reply With Quote
Page 1 of 3 123 LastLast
« D2a grille onto D2 | eurovox 5880 R »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!