Thread: Vibration/shudder

My left one on the front prop shaft.

http://www.aulro.com/afvb/good-oil/6...an-joints.html

The 80km/hr sounds all too familiar. Chock your wheels, handbrake off, put the car in neutral, climb under and spin the shaft, look at both joints, will be a small crack in one of them. Size of the crack does not matter.

Regards
Andrew

You need to be a little more specific. I have those exact symptoms, as far as you've explained it. I get a solid vibration through my seat at 80+. Its not the front tailshaft as this has been changed, and was still there with the shaft out. Its not the back shaft ( I think) as it reduced but I could still feel it. That leads me to believe that while its not the rear shaft, it is transmitting it. Its not upfront, as I get nothing thru the steering wheel, so I'm thinking rear axle or transfer case.


cheers
Nick

Originally Posted by Hastykiwi

You need to be a little more specific. I have those exact symptoms, as far as you've explained it. I get a solid vibration through my seat at 80+. Its not the front tailshaft as this has been changed, and was still there with the shaft out. Its not the back shaft ( I think) as it reduced but I could still feel it. That leads me to believe that while its not the rear shaft, it is transmitting it. Its not upfront, as I get nothing thru the steering wheel, so I'm thinking rear axle or transfer case.


cheers
Nick

Nick,

You might get some value from the Tech Bulletin covering driveline noise attached to the following post:

http://www.aulro.com/afvb/1515174-post22.html

cheers
Paul

Checked the front and rear drive shafts and can't see a crack anywhere. I wouldn't think it's the drive shaft, cos it's only happening in that speed range. Further digging had me thinking gearbox? Any way of checking the oil in the transfer case easily?

booya on the throne

Have you tried 3rd gear to see if it still does it?

What do you mean?

booya on the throne

I had a similar thing happen to me on Monday. The drive line only vibrated at around 80km/h. It progressed to happen when ever i was accelerating. On first inspection the uni joints looked okay. Once up on a hoist it was clearly a uni so have another look.

Ben

Originally Posted by Freightdog

Have you tried 3rd gear to see if it still does it?

Originally Posted by disco_disco

What do you mean?


booya on the throne

Drive with the rig in 3rd gear at 80km/hr

Originally Posted by Distokes

I had a similar thing happen to me on Monday. The drive line only vibrated at around 80km/h. It progressed to happen when ever i was accelerating. On first inspection the uni joints looked okay. Once up on a hoist it was clearly a uni so have another look.

Ben

I'm with Ben here. Have another look. See if there is sections which are a tad shinny. Like a said the smallest crack will do it.

Regards
Andrew