Thread: Flashing M&S lights

The ECU is probably the least likely thing to be causing the problem.

Low battery voltage will trigger the M&S, as will a faulty position switch. You really need to get the gearbox fault codes read to know exactly what is causing the problem otherwise you are just guessing.

There are numerous threads on flashing M&S if you search. The AULRO search engine doesn't work with three letter search terms so google for "site:aulro.com m&s"


cheers
Paul

Joe, if you post what suburb of Perth your in there may be someone nearby that has a nanocom that you can use to read the codes, I have one I live in Beechboro if that's any help

Roger

Thanks Roger, I live in Hocking, If you have time I'd love to come around and sort this problem, I'm just learning the Disco, my last Landie was in the 80's -90's and was a IIa a lot simpler machine. I'm planning on buying a Nanocom they seem to be the answer it would be good to see how they work.
Joe

I've just sorted the exact same issue out with a clean out of the position switch - I figured I may as well clean it out and see if that does the job, before spending moneey on an overpriced component (if you see what's in it you'll be scratching your head as to why it's so expensive)

One of the contact tracks on mine was noticably dirty, but no sign of water ingress otherwise, I just cleaned up the tracks and there was clean excess contact grease around the switch which I used on the clean contacts. I used some rivets to seal the unit back up along with some hylomar on the seal and the car drives brilliantly - I wish I'd done it months ago.

About 2 hours work in it end to end, just make sure you do it before going out in the car as the exhaust is close to where you need your arms.

Rich

Thanks to all that posted ideas and their solutions and thank you to Roger for plugging in his Nanocom, looking at the faults and sharing his knowledge. Roger like Paul did not believe the computer was to blame and the faults did not think so either. Thanks Rich for the descriptive strip down it helped immensely.

I stripped out the selector switch, drilled out the rivets and found a bit of grime around one spot there was no water, I cleaned it with contact cleaner and re-greased with dielectric grease and reassembled I bought some 5/32" counter sunk Phillips head bolts from Bunnings $3.50 instead of riveting back together; in-case dis-assembly was required again. The only issue was the Landie would not start I could not have been very diligent when marked its position, pulled the exhaust again and adjusted till it started in P and N and the R lights were on, took 2 min, bolted up test drove up the gears in and out of reverse with no flashing lights.

Once again thanks every one.

Joe

I wish I was so lucky. Did the same service to mine some time back but no improvement. I suspect the loom from the box to the ECU but presently lack the time and motivation to explore further.

Originally Posted by John W

I wish I was so lucky. Did the same service to mine some time back but no improvement. I suspect the loom from the box to the ECU but presently lack the time and motivation to explore further.

See if you can find someone local with a Test Book/Nanocom/Hawkeye to read the EAT ECU codes.

I've posted a compilation of diagnostic flows for Disco P-codes here:

http://www.aulro.com/afvb/electronic...ml#post1631098

Gearbox related faults include: P0600, P07xx, P188x.

You'll also need a copy of the Electrical Library pdf from RAVE (linked in the post above).

There is an overview of EAT ECU diagnostics attached to this post:

http://www.aulro.com/afvb/electronic...ml#post1553858

cheers
Paul

Thanks Paul will look into it.