Results 1 to 5 of 5

Thread: M & S lights flashing on D2 after axle change

  1. 28th April 2012, 02:09 PM #1
    Capacious's Avatar
    Capacious
    Capacious is offline Fossicker
    Join Date
    Jul 2010
    Location
    Sydney
    Posts
    93
    Total Downloaded
    0

    M & S lights flashing on D2 after axle change

    Hi all,

    I've just swapped out my standard axles for Hi-toughs. I think I did the job pretty carefully... aside from a little brute strength required to remove the rear axle stake nuts.
    Now I have the M and S lights flashing... have I stuffed something up?

    Gear selection is fine and it drove the 2m test in 1st and reverse fine...
    Reply With Quote Reply With Quote
  2. 28th April 2012, 02:48 PM #2
    Tombie's Avatar
    Tombie
    Tombie is offline OldBushie
    Join Date
    Apr 2012
    Location
    Whyalla, SA
    Posts
    7,553
    Total Downloaded
    0
    Did you have the radio on or doors open whilst you worked?

    Your battery is probably low (or failing)...

    Give it a good charge
    Reply With Quote Reply With Quote
  3. 28th April 2012, 02:49 PM #3
    Tombie's Avatar
    Tombie
    Tombie is offline OldBushie
    Join Date
    Apr 2012
    Location
    Whyalla, SA
    Posts
    7,553
    Total Downloaded
    0
    BTW - if the lights are flashing - it drove forward in 2nd
    Reply With Quote Reply With Quote
  4. 28th April 2012, 03:24 PM #4
    Capacious's Avatar
    Capacious
    Capacious is offline Fossicker
    Join Date
    Jul 2010
    Location
    Sydney
    Posts
    93
    Total Downloaded
    0
    Thanks I had read that but seems so strange! Hopefully it works.

    The D2 hasn't been driven in a few weeks so the main battery is very low (10.8v), secondary battery still has 12.8v tho. It's on charge now so will see how it goes tomorrow.
    Reply With Quote Reply With Quote
  5. 28th April 2012, 03:24 PM #5
    justinc's Avatar
    justinc
    justinc is offline Swaggie Vendor
    Join Date
    Aug 2006
    Location
    Kingston, Tassie, OZ.
    Posts
    13,728
    Total Downloaded
    0
    Ditto for battery voltages, try disconnecting and charging the battery fully.

    JC
    Reply With Quote Reply With Quote
« Replaced the exhaust gasket on TD5 | abs shuttle valve »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!