Thread: TD5 auto 2001 wont rev over 2500

I have heard this could be a symptom of a failed fuel pump..
Can you hear the pump before starting the engine?

Yea can hear fuel pump before starting engine, i thought it was in like a limp home mode

Failing at 2500 rpm under load is a sign of fuel being cut due to excessive boost. Excessive boost is often caused by a failed boost modulator but sometimes caused by a faulty wastegate modulator or a frozen wastegate.

Thanks for that will check it out in the morning,

Thanks for the start point on my td5, i found my turbo wastegate sticking at full open position, (not the fault of actuator) the actual shaft has flat spots on it, so i need to find a new shaft and flap, if i can replace it, it looks like a fun job. ive adjusted it back so it doesnt quite go to the position it sticks at, lost a little boost, but can put up with that till i get it fixed.

Mine did that except at 3000rpm. Was the MAF sensor. Replaced with OEM siemens MAF for $130 from the UK and now keeps pulling. Gear changes from my auto are also alot better now.

The above symptom is also consistent with the turbo sense line coming loose or splitting. If you have been the engine recently and played around with the air box this can happen easily. Again the result is the turbo waste gate not operating properly.