When the CDL is disengaged it's just a std diff running lengthways down the vehicle rather than across. When locked it's like a series in 4WD.
Have checked rave and also searched on here but cannot figure out what method the transfer case uses to drive both the front and rear axle when cdl is disengaged.
I'm guessing it may be similar to what mitubishi had with a 'viscous hub' or something like that, but cannot find any reference, and if it does what percentage of drive is sent too the front axle?
cheers james
When the CDL is disengaged it's just a std diff running lengthways down the vehicle rather than across. When locked it's like a series in 4WD.
Thanks for that, does that mean then ,that when both axles have equal contact on the ground ,engaging cdl will not improve traction?
It will prevent the front or rear wheels spinning at differant speeds
to answer your question depends on terrain front in mud rear on hard pack it will improve
Ie
Locked will give 1 for 1 front to back (good traction) 50/50
Unlocked can give 2 for 1 (poor traction) 75/25
Vm
The last of the Classics and P38's had the Borg Warner transfer case with viscous coupling in parallel with the (cogs etc) centre diff. The VC locks up under large speed differance F/R shafts, and hence takes the 'diffing' load off the gears & cogs centre differential.
The BW box has it's own problems and quirks, - differant behavious in both cars....![]()
It means you will be able to spin two wheels instead of just one. One back one front. Is it even possible to have equal traction, except in theory?
2002 D2 4.6L V8 Auto SLS+2" ACE CDL Truetrac(F) Nanocom(V8 only)
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks