Results 1 to 4 of 4

Thread: Tied own / anchor points for storage.

  1. 29th April 2014, 03:30 PM #1
    turps's Avatar
    turps
    turps is offline Master
    Join Date
    Feb 2011
    Location
    Bendigo
    Posts
    295
    Total Downloaded
    0

    Tied own / anchor points for storage.

    I am about to build a storage unit for my disco. Currently just have some very temp tie down rails attached to the 4 tie down points.
    How have people bolted there cargo or draw systems to the floor?
    As I looked at the factory tie down. But can't see how they are attached.
    Reply With Quote Reply With Quote
  2. 29th April 2014, 07:14 PM #2
    twr7cx
    twr7cx is offline YarnMaster Supporter
    Join Date
    Feb 2011
    Location
    Hobart, Tasmania, Australia
    Posts
    3,828
    Total Downloaded
    0
    I use four of these:



    They're mounted to the sides of my cargo drawers, connect to the factory tie down points.
    Reply With Quote Reply With Quote
  3. 29th April 2014, 08:09 PM #3
    GregTD5's Avatar
    GregTD5
    GregTD5 is offline Master Supporter
    Join Date
    Jan 1970
    Location
    Perth West Aust
    Posts
    249
    Total Downloaded
    0
    Turps, i also made my own cargo drawers for my D2. What I did was used a big bit of ply for the base and removed the tie down points at the front. I then bolted the front of the ply to the tie down point bolt holes. So the drawers aren't as wide as could be.
    For the rear I left the tie down points in place, but used turnbuckles as per previous post to hold the drawers to the base.
    I have installed the tie down points as removed from the front of floor onto the newly made drawer system.
    Sorry, no pics on this computer, but if interested, send your email in a PM and I will take pics and send.

    Greg
    Reply With Quote Reply With Quote
  4. 1st May 2014, 07:57 PM #4
    turps's Avatar
    turps
    turps is offline Master
    Join Date
    Feb 2011
    Location
    Bendigo
    Posts
    295
    Total Downloaded
    0
    Was going to try and avoid the turnbuckle route. But I will have to have a better look. As I couldn't see how they bolted down.
    Thanks for the tips.
    Reply With Quote Reply With Quote
« electric brake controller | Tyre shop advice, true or not »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!