Thread: Discovery 2 won't start

that fgtech is also OBDII so forget about it

If battery is ok another thing to check is the starter fuse under the bonnet, we had this once.

Can you hear the fuel pump with ignition on , not cranking?

Originally Posted by discorevy

Can you hear the fuel pump with ignition on , not cranking?

Hi it cranking . the check engine ligth not on. i can read abs, reset abs, read eka code with x431 but not read the engine.

thanks

No , don't let it crank , just have ignition on so lights on the dash , then walk to the back of the car and listen for a sound

Originally Posted by jorge_costa_cv

Hi it cranking . the check engine ligth not on. i can read abs, reset abs, read eka code with x431 but not read the engine.

thanks

what message do you get, if you get "data link error" it can be a feed/earth issue or even ECM failure too, can you see the engine management warning(MIL) working on ignition self test?

Originally Posted by sierrafery

what message do you get, if you get "data link error" it can be a feed/earth issue or even ECM failure too, can you see the engine management warning(MIL) working on ignition self test?

No the engine management warning not workink in any condition stilll off all time

you need dedicated tester for that cos it must work on self test regardless of the ECM cos the warning light self test is made by the instrument pack...if it was so from the beginning maybe the previous owner blanked it to hide a fault or something cos it's very rare for those LED's to fail.... if the proper tester gives that data link error message it's quite likely that there's a wiring issue or the ECM is fubar'd