Madman EMS1
Hey
after a kit to monitor exhaust gas temps
whats everyone using?
Whats the GO???
cheers
Bronson
Madman EMS1
I'm considering one of these Automobile Gauges : auberins.com, Temperature control solutions for home and industry
I installed an Auber Instuments EGT guage a few years back. I have had no problems with it.
Remove the exhaust manifold to install it though as getting the swarf out from drilling and tapping the probe into the manifold would be just about impossible otherwise. You can deweb the manifold at the same time.
I installed the guage into the ash tray and also got a cheap buzzer(Jaycar) which is triggered by the temp guage at 703 deg C(which stops you having to watch the guage). Money well spent me thinks.
Cheers,
Jason
X3 for aurberins
Hey Vern,
Best spot for the probe?
Cheers mate
I have just installed one of these: Exhaust Temperature - Pyro/Turbo (EGT) Special
Thermocouple is installed through the EGR blanking plate. I am seeing temperatures up to 700 deg towing a 2.5 ton van.
+ 2016 D4 TDV6
LROCV member #131
1999 build D2 TD5 Auto, Mantec snorkel, 2" LRA spring lift, ARB on board air, Ashcroft ATB, CMM air ram CDL shifter, swag & gold pans ....
Currently running a madman ems1. Had a set of "race tech" eBay gauges on my D1. Both seem good.
For ease of install, u can't beat the egr blanking plate location.
ImageUploadedByTapatalk1429999874.774860.jpg
As seen here in red I believe.
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks