Results 1 to 7 of 7

Thread: Td5 aircon bearing noisy

  1. 26th May 2015, 07:47 AM #1
    Acrabtree
    Acrabtree is offline Fossicker
    Join Date
    May 2013
    Location
    cairns
    Posts
    22
    Total Downloaded
    0

    Td5 aircon bearing noisy

    Hi.
    My aircon clutch/pulley is noisy when switched on?

    Does anyone know the part number for the bearing in the aircon pulley/clutch assy as its my daily driver and would like to get the bearings first from the local bearing shop before i pull it apart.

    Is the idle pulley bearing the same part number as the aIrcon bearing?

    Thank you
    Reply With Quote Reply With Quote
  2. 26th May 2015, 06:17 PM #2
    Acrabtree
    Acrabtree is offline Fossicker
    Join Date
    May 2013
    Location
    cairns
    Posts
    22
    Total Downloaded
    0
    No one................


    Surely someone has replaced them?
    Reply With Quote Reply With Quote
  3. 26th May 2015, 08:27 PM #3
    goanna_shire's Avatar
    goanna_shire
    goanna_shire is offline Master Subscriber
    Join Date
    Feb 2009
    Location
    Townsville QLD
    Posts
    258
    Total Downloaded
    0
    HI,

    I am in the same boat. Daily driver and squeaky bearings, Or maybe belt or both .

    I think the tensioner needs to be replaced completely if it is cactus.


    Cheers,
    Brian.
    Reply With Quote Reply With Quote
  4. 27th May 2015, 12:12 PM #4
    Acrabtree
    Acrabtree is offline Fossicker
    Join Date
    May 2013
    Location
    cairns
    Posts
    22
    Total Downloaded
    0
    I replaced my belt tensioner with a genuine unit 6 months ago so its shouldnt be that.
    I did find my aircon pulley bolt loose an re-loctited the tread but still makes the noise under load.

    I will have to pull it off an measure then do a write up.
    Reply With Quote Reply With Quote
  5. 27th May 2015, 04:01 PM #5
    Pierre
    Pierre is offline Wizard Silver Subscriber
    Join Date
    Jan 1970
    Location
    Blairgowrie, Vic
    Posts
    1,106
    Total Downloaded
    0

    Thumbs up Bearings etc

    AFAIR, the bearings on D1 and D2 air conditioning compressors are the same. The compressors are Denso built. Try Ashdown Ingram for a start point.


    I think there has been a thread about this in the past...search function is your friend.


    HTH


    Pete
    Last edited by Pierre; 27th May 2015 at 04:03 PM. Reason: add
    Dizzie, 08 D3 TDV6 SE
    Reply With Quote Reply With Quote
  6. 27th May 2015, 07:01 PM #6
    steve_a
    steve_a is offline Master
    Join Date
    Dec 2008
    Location
    Yatala Vale, Adelaide, SA
    Posts
    340
    Total Downloaded
    0
    Order a kit off ebay, you may find you need the full kit if the bearing has gone enough to start to chew the clutch.
    There is a good page on this somrwhere which I'll link to later, but some notes!
    There is a large circlip on the front, under the steel front plate, remove this. If you think there isn't, clean and relook, there is! I ripped the front off my compressor with the puller because I looked but didn't see it.
    When replacing the bearing in the pully, bear on the outer edge of the bearing hole only, don't use the outer edge of the pully, it will deform.
    Getting the old one out is hard, putting the new one in pretty easy.
    If you learn from my mistakes then it's doable, but I stuffed up from start to finish and ended up buying a new compressor.

    Sent from my SM-T530 using AULRO mobile app
    Reply With Quote Reply With Quote
  7. 29th May 2015, 07:23 PM #7
    Acrabtree
    Acrabtree is offline Fossicker
    Join Date
    May 2013
    Location
    cairns
    Posts
    22
    Total Downloaded
    0
    Ok update. I pulled the aircon bearing out an it was pretty average and while i was there i also pulled the idler bearing. The part numbers for the Td5 engine are
    -Aircon pulley- 30bgs10dst $24
    -IDLER BEARING- 6303 $12

    But in the end i found the harmonic balancer has a wobble so its looking like an order from the Uk. What does everyone think of bearmach parts?????

    Im finding it hard to find a genuine harmonic balancer an im not going to buy a britpart item. Lol.

    The d2a auto has had alot of treatment(money) in the last year so im hoping its going to give me an the family some good times. Otherwise....................
    Thank you
    Reply With Quote Reply With Quote
« metal radiator hose | D2 battery warning light »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!