Results 1 to 6 of 6

Thread: D2 2004 V8 stalls when selecting gear

  1. 4th May 2018, 03:16 PM #1
    Mickyg
    Mickyg is offline Fossicker
    Join Date
    Jul 2017
    Location
    Darwin
    Posts
    49
    Total Downloaded
    0

    D2 2004 V8 stalls when selecting gear

    Most of the time it stalls when I select drive or reverse, occasionally the next intersection when I stop too, but never after that. No misses drives perfectly. But switch it off and try again and stalling.
    Ive replaced the battery and the xyz switch, now I'm thinking wiring as I get a P0335 circuit malfunction. Does anyone know what's involved to access the crank sensor wiring...will pulling the heads off expose it?
    I'm also going to drill out the transmission tunnel plate and check the xyz loom.
    Anyone in Darwin have a good diagnostic unit that wont charge too much?
    Anyone else had a similar issue?

    Thanks

    Mick G
    Reply With Quote Reply With Quote
  2. 4th May 2018, 06:29 PM #2
    ozscott's Avatar
    ozscott
    ozscott is offline ForumSage Subscriber
    Join Date
    Oct 2007
    Location
    Brisbane West
    Posts
    7,373
    Total Downloaded
    0
    Crank sensor is accessed from under vehicle (to remove cover and bolts holding CPS in against flywheel) and on pass side down past exhaust manifold to unplug.

    Cheers
    Reply With Quote Reply With Quote
  3. 4th May 2018, 07:16 PM #3
    Mickyg
    Mickyg is offline Fossicker
    Join Date
    Jul 2017
    Location
    Darwin
    Posts
    49
    Total Downloaded
    0

    crank sensor

    I replaced the crank sensor, I'm worried I disturbed or damaged wiring going it.
    Reply With Quote Reply With Quote
  4. 4th May 2018, 09:09 PM #4
    ballbag
    ballbag is offline Master
    Join Date
    Oct 2012
    Location
    Wollongong
    Posts
    578
    Total Downloaded
    0
    Check electrical connection at idle air control valve.
    Reply With Quote Reply With Quote
  5. 4th May 2018, 09:18 PM #5
    Mickyg
    Mickyg is offline Fossicker
    Join Date
    Jul 2017
    Location
    Darwin
    Posts
    49
    Total Downloaded
    0
    I'll try that, been told to clean the throttle body too. definitively seems electrical.
    Still wonder how sensitive the xyz switch adjustment is, but everything works as it should, rear wiper, dash indicator etc.
    Reply With Quote Reply With Quote
  6. 4th May 2018, 09:24 PM #6
    ballbag
    ballbag is offline Master
    Join Date
    Oct 2012
    Location
    Wollongong
    Posts
    578
    Total Downloaded
    0

    D2 2004 V8 stalls when selecting gear

    You can check XYZ switch on the dash display. Dash gear readout should match selector position.

    Assuming engine is not cold, engine brain will raise idle if tranny is in a drive gear.

    To test, move selector to be in no position (eg. halfway between D and N), so dash display is blank. Idle speed should increase.

    If it doesn’t, the IACV isn’t opening.
    Reply With Quote Reply With Quote
« Non Starting TD5 | Front pulling hooks »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!