D2 Will Not Start in Park after XYZ Switch Work

matt76 · 10th March 2020, 02:21 PM

Hey guys,

Have had issues with XYZ switch, removed and cleaned as per multiple online instructions, videos etc. Initially had it stuck in limp home mode and after adjusting further today have all lights on dash and auto shift panel working as they should with no more flashing M and S.

Only 1 big remaining issue, will not start in Park, have to jiggle the shifter around neutral to get the car to start and am reluctant to mess with switch again given the good result re all gears working correctly with no flashing green lights.

Interestingly rear wiper does not come on either when in reverse with wipers on.

Any gurus out there with advice on this, much appreciate any input at all.

Thanks heaps
Matt

**DazzaTD5** · 10th March 2020, 05:45 PM

I dont think the adjustment is correct, i cant remember if the adjustment is done in park or neutral, somebody will chime in soon enough

Once its close, i nip it up then gentle tap either way until spot on, all while trying to not get the exhaust too hot

**AndrewMilne** · 11th March 2020, 01:14 AM

a

**PhilipA** · 11th March 2020, 07:57 AM

It's done in neutral.
N on selector N on dash should work.
You should also check that the wiring has not chafed at the back of the console where it passes over a bolt head. The very left corner as it bends down towards the XYZ. Easiest if you remove the console top!
Regards PhilipA