M&s lights

**lewy** · 12th March 2021, 03:45 PM

Cruising along suddenly cruise control drops out m&s lights and d light are flashing. I have drive and reverse only. Seems I only have fourth gear with no converter lockup. Code po705,is this the xyz switch

**Bohica** · 12th March 2021, 04:56 PM

Could be.
Search says
Just a moment...

**Markf** · 12th March 2021, 05:14 PM

Originally Posted by lewy

Cruising along suddenly cruise control drops out m&s lights and d light are flashing. I have drive and reverse only. Seems I only have fourth gear with no converter lockup. Code po705,is this the xyz switch

I've had the same thing and it was the loom from the XYZ switch being abraded where it crosses the transmission. The "P" clip that is supposed to hold it (the loom) in place had carved through the insulation.

**lewy** · 12th March 2021, 05:16 PM

Will give the converter a workout tomorrow getting home.

**lewy** · 13th March 2021, 07:24 AM

Originally Posted by Markf

I've had the same thing and it was the loom from the XYZ switch being abraded where it crosses the transmission. The "P" clip that is supposed to hold it (the loom) in place had carved through the insulation.

Can those wires be reached from the bottom. Or better to remove the consul

**PhilipA** · 13th March 2021, 08:22 AM

Better to remove the console.There are 13? Rivets to drill out.

regards PhilipA

**Markf** · 13th March 2021, 09:53 AM

Originally Posted by lewy

Can those wires be reached from the bottom. Or better to remove the consul

Remove the console. There are 13 rivets to drill out (and replace) and be careful of a couple of sharp edges that are waiting for you. You shouldn't lose too much knuckle skin.

**Tins** · 13th March 2021, 10:37 AM

Originally Posted by Markf

(and replace)

With blind rivets.

**lewy** · 13th March 2021, 12:03 PM

Originally Posted by Markf

You shouldn't lose too much knuckle skin.

there is little left on the old knuckles as it is.

**lewy** · 13th March 2021, 12:15 PM

So made it the 150 odd kms home this morning with the lights gone and everything working as it should.I had cleared the fault yesterday afternoon last thing,fired it up this morning and drove it home,think i will start with a fluid level check first incase but if there is no leaks it cant be low[perhaps] leaning towards the wires instead of the xyz switch at this stage as the last 30 kms with the fault was pretty rough corrugations so possibly shook the wires into the right place, If the wires that were shorting suddenly were not shorting would of the M&S lights etc gone out or only when the fault was cleared.

Thread: M&s lights

Thread Tools

M&s lights

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions