`Just thought I'd show off my new rear tail shaft dc mod.
The adapter plate is 22mm thick with counter bored holes for the original stud pattern and tapped holes for the new pattern.Center hole is an exact fit for both differing size flanges. The joint is quite a lot bigger than the landy dc joint
That looks very strong Mark. I guess the factory one was under a lot of strain with the increase in angle brought about by the 4inch lift. I take it you removed the rotoflex donut as well?
My bro in law helped me out, 5inlift and had slight vibration at 90km then would go, got rid of the donut a long time ago, the lot was balanced before it was bolted up.
Reply With Quote
Master
Posting Permissions
Bookmarks