Thread: Nanocom Evo faulty ?

Had my Nanocom Evo for about a Month or so & it seems to have developed a Fault.
When I first tried it, it powered up straight away & I put unlock codes etc into it.
All good. Used it a few more times no worries, But its been in its box for a while & today I found it to be Very slooooow , Took about 2 minuits to go thru its startup routine , where usually it took about 5 seconds, & once started after pressing my option I have to wait about 45 -60 seconds for it to respond, & interrogating the ECU is hit & miss, most times coming back with a comms error.

When it does work it lists some unclearable faults that dont exist, like A/C Clutch overheat - like I doubt that even has a sensor on it. There is no oil in the loom & earths are all good.

Shut it all down & tried using a 12v adaptor rather than the OBD plug & same thing, like over a minuite to fire up & shut down.

Is this a known issue & how do I resolve it.

Thanks Don

Sounds like the oscillator for the processor is way off (under) frequency. That, or the clock multiplier in the micro is incorrect somehow.

Other than re-flashing firmware I can't offer any useful suggestions, sorry.