Results 1 to 3 of 3

Thread: Problems after msv2 upgrade

  1. #1
    Join Date
    Jun 2007
    Location
    Margaret River
    Posts
    800
    Total Downloaded
    0

    Problems after msv2 upgrade

    After software and firmware upgrade to latest 1.33
    When hooked up to rrs to explore and clear some faults- next morning flat battery in vehicle
    Recharge battery and vehcle running but now audio controls on steering wheel are mixed up - mode increases volume

    Im thinking the msv2 is not allowing the ecus to go to sleep and drained the battery
    Any suggestion on what could be going on

  2. #2
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,036
    Total Downloaded
    0
    Did you change any CCF settings? If not then perhaps the battery going flat caused a mix-up so suggest that you disconnect the battery for a minute.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  3. #3
    Join Date
    Jun 2007
    Location
    Margaret River
    Posts
    800
    Total Downloaded
    0
    No, didnt change any configs
    Just scanned for faults then used clear faults from entire vehicle cmand
    Yes i tried disconnecting the battery to reset the ecus but radio controls on wheel are still muddled
    The battery is holding its charge after going flat following use of msv2

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!