Thread: Nanocom auto on

Don't think it can auto on ... touch the screen with your finger for a few seconds and it will power on. It can be set to auto load various modules at power on ... mine's set to power up in instrument mode.

... and yeah, sounds just like my wife with the heavy right foot !

You wouldn't happen to know where that setting is for turning the instrument mode on?

Originally Posted by turps

You wouldn't happen to know where that setting is for turning the instrument mode on?

From page 10 of the Evo Manual - which you should down load from BBS

Startup Settings:

[Picture didn't upload]

When you select this option you will be presented with a list of possible applications (use the up and down scroll arrows for the full listings). The following are examples of the startup options you have:
Selecting "Normal" means that the unit will start with its main menus as listed above.
If for example you select TD5INST.APP and save the settings, the next time you restart the unit, it will automatically load the TD5 Instrument panel after boot up. To exit this mode you simply press the [cross] in the bottom right corner of the screen and the unit will exit and restart in normal mode. Remember, by selecting something other than Normal in this section, it will set the Nanocom to start in that mode until changed.
When the ignition is switched off, again the unit will automatically end the application (with the exception of normal mode) and go into power save mode. This is a normal situation and should not be confused with the unit behaving in an incorrect manner.

Originally Posted by Fluids

touch the screen with your finger for a few seconds and it will power on

cheers. i was having the same problem