Thread: Nanocom not connecting to ECU

Ean, are you using it as a display for engine as default?
I've found with mine that I need to change the startup mode so it doesn't act as instruments, then unplug it, then plug it back in.

Fraser

Gday Fraser,

Not sure, im not that good at driving it yet, this is the 1st time i,ve used it with the laptop, but when I tried to use it on its own it said the same thing.

Looks like I have some reading to do..


Cheers Ean

Originally Posted by Ean Austral

Gday Fraser,

Not sure, im not that good at driving it yet, this is the 1st time i,ve used it with the laptop, but when I tried to use it on its own it said the same thing.

Looks like I have some reading to do..


Cheers Ean

Hey Ean

I find with the SLABS ECU that I get right thru to the last button push to read the faults, THEN I turn the igintion on (dash lights on), then read faults, and most times it will read OK. Engine on, no work. Ignition off/aux' position ... no work. If it doesn't read first time like this, ignition off, setup to read, ign' ON and read.

Hope that gets you there.

Kev..