Thread: painting advice

Originally Posted by victa125

Hey Taff, Some things you should know. For a good job a gravity gun is required,1.4 set up. Reason being with suction gun you have to over thin paint to get it to spray. Not good with 2 pak as chages ratio paint to hardener, it relies on this for proper drying (called crosslinking). Follow manufacture instruction on ratio. Dont over thin usually 10% max. As previously stated clean environ is critical. Cleaning job must also be thorough, use plenty of wax and grease remover with clean lint free rags. Contaminents on the surface can give you hell. Use tack rag, yellow one just prior to application. Test spray on something to check spray pattern 6 to 8 inches. All good? What you are to acheive with your first coat is an even medium wet coat even being the opperative. Do not apply light thin coats. After first coat has set up.(test on masking or such, when touched with finger tip should feel like sticky tape but paint not get on finger) Depending on coverage may need only two coats if so second is full wet coat if three second as first followed by final. With 2 pak Direct gloss any more than three is not required.Drying times vary but usualy 20hrs at 20c down to 30min at 60c. If have to rub, buff try to get this within 3 days as paint is more compliant. Do not rub with coarser than 1500 and use 2 pak cutting compound else you will not get the scratches back out. Can also earth body to concrete helps with static. When finnished have beer and sing ( I did it my way).

thanks mate this is exactly what i was after. i've got mixing pot's and have been told 4.1. i'll earth the body though and i'll be having plenty of beers when finished.
jason

Originally Posted by Tank

Jason, that site wont open, is the URL correct, or is it just me, Regards Frank.

i'll try again


http://www.stephen.hull.btinternet.c...nmetallic.html