Thread: LANDROVER PARTS NEEDED

Originally Posted by foz.in.oz

My Defender does

I think you'd better double check that .

Your Defender tail light lens is part of the light housing. The 2 screws hold the whole assembly to the body.

Originally Posted by 5teve

is there anybody that has a working drinks holder?

Thanks

Steve

I did have... until a big bump and coke went everywhere (no not off road in Adelaide... anyone who has seen our ropads will understand why we like driving off road... it's smoother!)

the coke got sticky and it didn't slide properly so took it out and cleaned it up and it worked well.... just can't get it back in properly. Looking at the manual I have to remove both sides (coin tray and ash tray etc)

So if anyone else is thinking of pulling it out.. make sure you follow the instructions for getting it back in!

speaking of the drink holder... what a stupid size it is. only good for cans. is there a repalcement that can actually hold a regular sized drink?

Originally Posted by p38arover

What's a tail light cover?

Originally Posted by Scouse

I assume 'discoMY2003' is new to Land Rovers & is assuming the tail light lens is available separately.

Little does he know that LR parts are only available as an assembly so he'll have to buy the rear half of a Discovery to get the bit he wants .

He could mean the protective cover.
RichCatalog

Try Rovacraft in bayswater 9377 0080 and ask for Ian.
I get nearly everything off them and they're good at sending stuff by courier as well.
Alan.

Originally Posted by simonr23

speaking of the drink holder... what a stupid size it is. only good for cans. is there a repalcement that can actually hold a regular sized drink?

I'm an ice coffee drinker and the only vehicle set up for this I have seen so far is the Daihatsu Feroza, has a perfect square holder to sit the carton in!