Thread: Exhaust on 2A Truck Cab

Hi Lionel,
You sound about the same stage as me then. Wiring was a big job as I started from nothing. Some of it is not pretty but everything works.

Have you put seatbelt in?

Cheers,
Russ

Originally Posted by Brisruss

Hi Lionel,
You sound about the same stage as me then. Wiring was a big job as I started from nothing. Some of it is not pretty but everything works.

Have you put seatbelt in?

Cheers,
Russ

Hello Russ,

There was a set of inertia reel seatbelts already installed on my Series 3. I need to replace the driver's and passenger 3 point belts because they are extensively frayed. Cross fingers that the replacement belts are installed by doing a straight bolt off - bolt on swap over!

I was lucky that I had a very good base to start off with on my Holden powered Series 3.

One of my other Series IIIs is a stock Land Rover 4 cylinder diesel and its exhaust pipe runs through the PTO cross member holes and then kinks to exit to the rear edge of the back spring hanger.

Have fun on your restoration.

Kind Regards
Lionel