Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: flywheel ID

  1. 9th December 2020, 04:31 PM #11
    akelly's Avatar
    akelly
    akelly is offline Wizard Gold Subscriber
    Join Date
    Feb 2007
    Location
    Cooroy, QLD
    Posts
    1,396
    Total Downloaded
    0
    oh wow that's a lot thicker than some of the reports I was getting. Think I'll knock a few thin ones up and test what works.
    Reply With Quote Reply With Quote
  2. 11th December 2020, 11:14 AM #12
    billtee
    billtee is offline Member
    Join Date
    Nov 2020
    Location
    australia
    Posts
    5
    Total Downloaded
    0
    Quote Originally Posted by akelly View Post
    oh wow that's a lot thicker than some of the reports I was getting. Think I'll knock a few thin ones up and test what works.

    Clutch slave cylinder ? | Land Rover UK Forums This page suggests 2mm but looks like a series 3 clutch using part number 591988

    S2A clutch question | Page 2 | Land Rover UK Forums This one shows a spacer and says 1/4 inch thick !

    so 2mm, 1/8 inch or 1/4 inch. - narrows it down a bit
    Attached Images Attached Images
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Over-heating Holden 186 | Red motor manifold needed »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!