Page 2 of 2 FirstFirst 12
Results 11 to 18 of 18

Thread: Coil Suspension

  1. #11
    Join Date
    Jul 2009
    Location
    Gold Coast
    Posts
    3,775
    Total Downloaded
    0
    Quote Originally Posted by ozscott View Post
    No mate because it doesnt matter how we cut it the fender will have more tyre on the ground and with those tyres pushing into the ground, with more inate balance with more clearance than a coil sprung d3. Having said that it would be a very nice tourer and solid offroader is my bet.

    Cheers
    D3's have one main disadvantage over a Defender, ramp over angle. A D3/4 from memory has about an extra 100 mm between the wheels comared to a 110.. If you have the same lift and tyre size compared to a 110 then the Disco has a lower limit to what it can crawl over as its way easier to end up sitting on your chassis rails. Especially so on a coiler which usually is limited to a 2" lift.

    Defender owners carry on about how most Disco owners aren't up to doing the tough tracks because we are afraid of wrecking our vehicles, but in reality you see very few brand or near new Fenders out there getting bashed around either. The vast majority are reasonably old bits of gear.

    Most Defenders out there getting seriously bush bashed are around the D1 or D2 age. So the jibes bout us being pansies afraid of scratching our Disco's is no different to the majority of late model Defender owners. (RVR110 excepted)

    My D3 with an e-diff, 32" MUDs, at off road height and with Llams set to max in Rock Crawl will go most places any Defender will go quite easy. Once you have a bull bar plus rock sliders and under body protection fitted you get a much higher level of peace of mind that your not going to destroy it in the rough stuff. Plus we don't have diffs to get hung up on in rocky terrain which is not that uncommon to happen to Defenders if the drivers don't pick their lines well.

    Will it go where a highly lifted twin locked Defender on 35" + MUDs and crawler gears can go? No it won't, but put the Defender back on 32" tyres and that would even it up considerably and possibly even give the advantage to the modded Disco. That is a bit of speculation though as not to many Fenders out there on 32's doing the hard stuff to compare against.

    D3's are very capable off road and on and are way nicer to drive than a Defender, it just depends on how far you want to go with mods and how much your prepared to scratch / dent your vehicle to find out.
    Cheers,
    Terry

    D1 V8 (Gone)
    D2a HSE V8 (Gone)
    D3 HSE TDV6 (Unfortunately Gone)
    D4 V8

  2. #12
    Join Date
    Oct 2007
    Location
    Brisbane West
    Posts
    7,372
    Total Downloaded
    0
    Terry the poster was talking about coiler d3 as was I. There is no comparison between a coiler d3 and an air sprung d3 which simulates live axle.

    Cheers

  3. #13
    Join Date
    Jul 2009
    Location
    Gold Coast
    Posts
    3,775
    Total Downloaded
    0
    Yes Scott your correct and I had already added a line that it would be some what harder with a coiler. Having said that I have been out with modded coiler D3's and seen them go places that my air suspended D3 struggled with.

    Personally I would not write off a well modded coiler D3 in the rough stuff, especially with a front and rear locker installed. ...

    The ramp over angle and max size of tyres is in my opinion the greatest limiting factors.
    Cheers,
    Terry

    D1 V8 (Gone)
    D2a HSE V8 (Gone)
    D3 HSE TDV6 (Unfortunately Gone)
    D4 V8

  4. #14
    Join Date
    Oct 2007
    Location
    Brisbane West
    Posts
    7,372
    Total Downloaded
    0
    Sorry mate I misread your post

    Cheers

  5. #15
    Join Date
    Jul 2009
    Location
    Gold Coast
    Posts
    3,775
    Total Downloaded
    0
    Actually you didn't misread it, I rewrote a section after putting it up and reading it myself, so you read it correctly.
    Cheers,
    Terry

    D1 V8 (Gone)
    D2a HSE V8 (Gone)
    D3 HSE TDV6 (Unfortunately Gone)
    D4 V8

  6. #16
    Join Date
    Mar 2010
    Location
    Newcastle
    Posts
    12
    Total Downloaded
    0

    Anybody want a set of Dobinsons?

    Hi all,
    I have a set of 50mm lift springs from my D3,free. I am in Newcastle.

  7. #17
    Join Date
    Nov 2010
    Location
    Adelaide
    Posts
    303
    Total Downloaded
    0
    Quote Originally Posted by murray073 View Post
    ...I have trouble finding things by searching on this site, might have to try the google search...
    Try adding site:www.aulro.com at the end of your search terms if you are using Google, you will use the full power of Google to search the forums. I tend to use Google rtahter than site's own search engines, it's much faster and normally returns better results!

    Don't worry about the underlining, that's the forum trying to be smart and it doesn't have a code function.
    Last edited by theresanothersteve; 30th September 2013 at 07:43 AM. Reason: Auto format explanation

  8. #18
    Join Date
    Mar 2012
    Location
    Northern Rivers NSW
    Posts
    120
    Total Downloaded
    0
    Or there're two Google search options at the bottom of each thread. One to search aulro, thye other bto search the web.

    Best Wishes,
    Peter

Page 2 of 2 FirstFirst 12

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!