Thread: Bull bar information

The cooper ltz are only 37mm larger in diameter and 30 mm wider 4% difference

Originally Posted by Tombie

Slight correction...

They haven't made the ARB bar with tabs for disco since the D3.... Inboard or out.

Are you talking about the antenna mounts??

Cause Phils ARB Bar on his D4 had them in the same spot as the old ARB bar, just going on what I've seen.

May have been a very early unit (or an old D3 production run.

But they haven't since 2011.

Canaussie

I do not know for sure but I believe the 285's rub on the bar return where it meets the front guard i.e. where you have to cut the flare off.

I think this is due to the width not the diameter.

I thought some one on here sold a set of the 285's because they were rubbing on the ARB bar.

Again - I am not sure so perhaps some one with direct experience will confirm.

Thanks Chuck, I have the tyres just sitting there in the garage saying put me on, put me on.....lol

Originally Posted by chuck

I thought some one on here sold a set of the 285's because they were rubbing on the ARB bar

Yeah they did Chuck. Michael (boofdtl) form Tyrepower Camberwell tried to fit them and they would not work.
The owner PM'd me to check if mine definately fitted with my OL bar.

Cheers, Craig

Mmm no I'm worried mine will rub!

Originally Posted by Tombie

May have been a very early unit (or an old D3 production run.

But they haven't since 2011.

Phils D4 was the first D4 fitted with an ARB bullbar, according to ARB Southern, the ARB bullbar for the D4 is different to the D3.