D4 Rocksliders/steps

As Tombie pointed out... the mounting nuts are NOT behind those grommets, they are behind black stickers.

There are 5 on the side and a further 6 underneath.

Easy job.... easier with a mate to hold one end though ;)

Quote:

---

Originally Posted by Bytemrk

Easy job.... easier with a mate to hold one end though ;)

---

Did mine and you'll love this...

LLAMS on Low, car set to low, 2 10L oil drums on their sides....

Quote:

---

Originally Posted by Tombie

Did mine and you'll love this...

LLAMS on Low, car set to low, 2 10L oil drums on their sides....

---

I think I like you system Tombie.....

Don't have to share the beers afterwards that way :angel: :p

Quote:

---

Originally Posted by Tombie

Okey dokey

Note it was still light - pre 1730

Attachment 79891

---

Looks good.
On my short list.
ATP VS GOE vs Brads.

Tombie, it looks like your ATP's allow one to keep the OE front mudflaps?
Very similar to GOE.

Cheers
Ron

Yes... Front mudflaps would still be ok, I haven't had them fitted.. As evidenced by the chipping of the leading edge of the rear flares.

Quote:

---

Originally Posted by Tombie

Yes... Front mudflaps would still be ok, I haven't had them fitted.. As evidenced by the chipping of the leading edge of the rear flares.

---

Front mudflaps don't help with the chipping. Unfortunately I've learnt that one the hard way.

Cheers,
Jon

Quote:

---

Originally Posted by jon3950

Front mudflaps don't help with the chipping. Unfortunately I've learnt that one the hard way.

Cheers,
Jon

---

Yep ...................... I'll second that. ;)

Quote:

---

Originally Posted by jon3950

Front mudflaps don't help with the chipping. Unfortunately I've learnt that one the hard way.

Cheers,
Jon

---

Strange,i have OEM front mud flaps, very little chipping.

I have done a lot of rocky high speed roads,my tyres are very badly chipped,they should actually be replaced.
I have even had to repaint and re tectyl the rear chassis rails,under the car, and the bottom front lip of the rear bumper is also very badly chipped,but the rear flares are fine.

The only thing i can think of is my tyres are 245 so probably a bit thinner than what you guys are running.

Quote:

---

Originally Posted by RHS58

Looks good.
On my short list.
ATP VS GOE vs Brads.

Tombie, it looks like your ATP's allow one to keep the OE front mudflaps?
Very similar to GOE.

Cheers
Ron

---

Well, if you're fitting by yourself, mine are alloy, so a lot lighter :D

Cheers,

Gordon

I have to reiterate Gordon's comment. To install the GOE sliders, hold in place with one hand while screwing in the bolt with the other. And there is no interference with the mud flaps.