Thread: Wiper Washers

Originally Posted by Redback

I went to a dealer about it, their reply, "Oh it came like that from the factory so we can't change it, we can give you the part, but you'll have to do it yourself" apparently the one way valves are working, but they are too close to the end and aren't holding enough water, so as far as they are concerned there's nothing wrong

So on that, we walked out with a oneway valve, that they gave us and suggested we put it closer to the washer bottle, so we did and it worked for a couple of weeks and then went back to the way it was.

Thank you again LR for your top notch customer service

Jeeze thats pretty bloody **** poor such a shame they couldn't give you a hand and fix it, i must say I've had no issues with my local LR dealer not that I've had anything needing to get fixed but just getting the strip above the windscreen and a service or 2 been good! As there is only one fella who does the servicing for LR as its a multi franchise dealer and not to many LRs in my local area so I've found it good so far!

It will also only wash headlights on every 5th use of the washers. Here're the full details:

HEADLAMP POWER WASH
If the headlamps are on, and there is sufficient
liquid in the washer reservoir, operating the
screen washer will also power-wash the
headlamps.

The headlamp power wash will operate on
every fifth operation of the screen washer,
provided the headlamps are still switched on
and 10 minutes (5 minutes in some markets)
have elapsed since the last headlamp wash.
Switching the headlamps or ignition off and
back on again will reset the cycle.

Note: If the fluid level sensor in the screen
washer reservoir detects a low level, the
headlamp power wash is inhibited.