Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Discovery 4 Restricted Gearbox Mode

  1. #11
    Join Date
    May 2010
    Location
    Brisbane, QLD, Australia
    Posts
    2,252
    Total Downloaded
    0
    Quote Originally Posted by BobD View Post
    I'm not sure what you mean by having the car in 4WD since it is always in 4WD. However, I agree with Graeme about the overheating transmission if you are not using low range. The D4's systems all adapt to off road driving when it is in low range so the car is designed to be used in low range in slow off road conditions.


    I once used high range on a beach in Esperance to try to keep up with my son in law who was flogging along at about 80 in his 80 series. After a while the car just started losing power until we got really slow and had to stop and then got bogged! I think the transmission was over heating so it cut engine power to reduce the heat. Put it in low range rock crawl, got out of the bog and then drove the rest of the way at a proper speed (below 60) in low range sand mode, with no further problems.


    I always use low range off road and have never had a problem, except that one time when I used high range and pushed the car too hard in difficult conditions.


    Bob

    Hi Bob,


    I'm on D4 #2 ... which hasn't been tested off-road yet (only 7K on the clock) but I can't wait to try it. I'm assuming it will be as good if not better than the 2009 MY10 that it replaced.


    I've driven on Fraser Is, Moreton Is and Bribie Is through wet and dry sand of varying thicknesses at lots of different speeds, based on the conditions (both low and high range) and have never experienced what you have described. These islands have a very high silica content in their sand and it becomes like talc when really hot and dry. Conversely it gets very heavy and deep when wet.


    I've stood outside my D4 after some of the harder driving and you can smell the transmission.....the heat off it. But never once did it do what you experienced.


    I've driven on all the varying surfaces at speeds close to 100kph and down to 5, in both low and high range ... never an issue.


    If you were to get a repeat of the scenario, I'd be asking LR why. As it just isn't right.


    Then again ... how fast were you actually doing LOL?


    Cheers,


    Kev.

  2. #12
    Join Date
    Dec 2011
    Location
    Forrestfield WA
    Posts
    1,306
    Total Downloaded
    0
    The 80 was driving in the wave zone on hard sand and through the salt water, hence he could do greater than 80. I was doing about 80 in soft sand on road tyre pressures well away from the water, so the car was working extremely hard, full power. I have never experienced anything similar before or since but I could only put it down to the car protecting itself from me.


    My car is an early 2010 3l SE and has now done 160,000km and is in for its major service. I do heaps of soft sand driving in WA but I always use low range and stick to about 60 max in most conditions. I only did that high speed run in high range to try to keep up without immersing the car in salt water, something I don't usually do. I also usually run on 18psi, not 40, so that was pretty stupid too. Once we lowered the tyre pressures and used low range we didn't have any further problems.


    The funny thing is the 80 got stuck at the end of the run in a creek flowing out to sea when he tried to climb the 1m high vertical bank and the flowing water sucked the back down into the sand. I broke an 11000kg snatch strap (and nearly went through the windscreen) trying to get him out but despite much digging and snatching with up to three cars at once he was stuck there all night while the tide rose to the top of the back seat. He ended up getting pulled out by a farmer in his heavy machinery the next day and drove home in front wheel drive when something jammed and the rear tail shaft broke.


    The 80 is still going over a year later and surprisingly doesn't show any evidence of the dunking. However, he spent days removing everything and cleaning everything to try to stop it rusting.


    Bob

  3. #13
    Join Date
    May 2010
    Location
    Brisbane, QLD, Australia
    Posts
    2,252
    Total Downloaded
    0
    Quote Originally Posted by BobD View Post
    The 80 was driving in the wave zone on hard sand and through the salt water, hence he could do greater than 80. I was doing about 80 in soft sand on road tyre pressures well away from the water, so the car was working extremely hard, full power. I have never experienced anything similar before or since but I could only put it down to the car protecting itself from me.


    My car is an early 2010 3l SE and has now done 160,000km and is in for its major service. I do heaps of soft sand driving in WA but I always use low range and stick to about 60 max in most conditions. I only did that high speed run in high range to try to keep up without immersing the car in salt water, something I don't usually do.


    The funny thing is the 80 got stuck at the end of the run in a creek flowing out to sea when he tried to climb the 1m high vertical bank and the flowing water sucked the back down into the sand. I broke an 11000kg snatch strap (and nearly went through the windscreen) trying to get him out but despite much digging and snatching with up to three cars at once he was stuck there all night while the tide rose to the top of the back seat. He ended up getting pulled out by a farmer in his heavy machinery the next day and drove home in front wheel drive when something jammed and the rear tail shaft broke.


    The 80 is still going over a year later and surprisingly doesn't show any evidence of the dunking. However, he spent days removing everything and cleaning everything to try to stop it rusting.


    Bob

    I had a little 'incident' on Fraser when the car was quite new and I was quite new to the car. I was avoiding the wave zone as well .... many good reasons for that including your point about not wanting a salt bath, but unfortunately came across an infamous Fraser Island wash-out at about 60kph....."ladies and gentlemen please brace for landing"!!! I'd hate to do the math on the actual energy the car absorbed and yet the only damage was limited to the wheels. Still completely drivable but not quite true after that. Incredibly tough car. Wheels fixed ... a few months later when the slight vibration kept annoying me ... and then good as gold!


    I have no idea why you had that loss of power but I doubt it was the conditions or your driving ..... just one of the LR's little quirks.


    We bag Toyotas ... but they aren't that bad, just not as good as a D4 :-). I did laugh recently at a mate who bought an LC 200 based on the issues I'd had with my first D4 .... which turned out to be a loose earth lead. He still looks at my D4 longingly ... I see his sideways glance ;-) Poor bugger!

Page 2 of 2 FirstFirst 12

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!