Printable View
The injector kits are new O rings, clamping plates (as they are sprung clamps), copper washers and pipes. No need to tell the ECU anything as all you are doing is pulling it out, and putting it back in the same spot. I found it quite therapeutic cleaning down the injectors and fitting the "refit kits" to them.Quote:
Originally Posted by Eric SDV6SE
Whats a kit cost?Quote:
Originally Posted by Grentarc
New clamping plates (with fresh curvature to force the injector hard into the cylinder hole under tension), new o-ring for the body and the return fitting, a new copper washer on the base of the injector and finally a new pipe fitting.Quote:
Originally Posted by Eric SDV6SE
In regards to the injectors, nothing needs doing other than putting them back into the same position you took them out of. [emoji106]
And she lives again! So far no air, fuel, coolant or oil leaks. Now I’ll change the ARB bushes on the front.
My split was a little smaller. I still have the original passengers side manifold as it hasn't split yet, but have a brand new one sitting here with all the other associated parts for when it does go.https://uploads.tapatalk-cdn.com/201...2d85a223b2.jpgQuote:
Originally Posted by DiscoJeffster
Mine started small but by the time I got to it, it stretched from one inch to three in no time.
My drivers was done 90,000km ago. I was considering doing both again but fingers crossed the replacement is stronger.
Looks like my left hand inlet manifold has a small crack, can't really see it but has oil in the right place. 195K. Unusually looks like LHS has gone first. I have been researching the parts. Do these look right, anything else I would need.
LR105956 LHS inlet manifold
LR116732 RHS inlet manifold
LR017436 Injector 1 refit kit with pipe (1 required)
LR017437 Injector 2/5/6 refit kit with pipe (3 required)
LR017438 Injector 3+4 refit kit with pipe (2 required)
LR029132 Cam Cover Gasket (2 required)
2 cam cover kits as below
Cam Cover / Inlet Manifold Fitting Kit 3.0 Tdv6 DA7014
https://www.island-4x4.co.uk/images/DA7014.jpg
right hand or left hand inlet manifold to Discovery 4 - TdV6 3.0 & Range Rover Sport - TdV6 3.0 Contains all seals and gaskets required to fit a right hand or left hand inlet manifold on
Discovery 4 - TdV6 3.0 & Range Rover Sport - TdV6 3.0
Kit contains - 1 x EGR Gasket - LR038333 3 x Lower Injector Seal - LR032818 3 x Injector O Ring - LR022992 3 x Top Injector Seal - LR054612
1 require per manifold
Thanks
Gerry
I’ve not used a kit before, instead ordered the parts. I have both the balance pipe and high pressure pump to rail pipe for the LHS at home unused. I’d practically give them away if you really want to use them, but I couldn’t get in there to fit them so reused mine. Yes that’s not advised but I know of many independents who have without issue. I await mine to burn down
Cam cover gaskets are already installed onto the new manifolds/ cam covers.