19" Maxxis AT Tyres

Quote:

---

Originally Posted by Odysseyman

Not in 19”. And not Light Truck construction.

And just for the record Light Truck tyres are not intended to be run at 80psi unless you are loaded to their load limit. Which with a 114 load rating would mean you would have 2360kg on your rear axle - way above any manufacturers specifications for rear axle load and really only there as a safety margin. Tyre pressures are then set according to the load they actually carry.
David

---

Not in 19. Funny how they don't do that and jump straight to the 20. It's though they are trying to avoid supplying tyres to Disco 4s. And let's face it, a 20.inch rim doesn't scream a need for a LT [emoji1787]. And yep, posted above about LT pressures.

Cheers

[QUOTE=mfpoli;2527940]Thanks Justin. Finally a light truck tyre in 19 inch! This is going on the shopping list. Hopefully the reviews are favourable.....ie minimal road noise, great puncture resistance, great handling in wet, etc :D and that there are enough stock in the country when time comes to changing the Wranglers!

Mario[
poor reviews, at my wits end, trying to find a good all rounder

[QUOTE=stuarth44;3203608]

Quote:

---

Originally Posted by mfpoli

Thanks Justin. Finally a light truck tyre in 19 inch! This is going on the shopping list. Hopefully the reviews are favourable.....ie minimal road noise, great puncture resistance, great handling in wet, etc :D and that there are enough stock in the country when time comes to changing the Wranglers!

Mario[
poor reviews, at my wits end, trying to find a good all rounder

---

Very noisy!! I moved off these to Duratrac and was much happier. Much noisier than the Duratrac

Quote:

---

Originally Posted by ozscott

[emoji1787][emoji106]. I thought some D4's had 18 inch but for those on bitumen vehicles with 19s and 20s Falken AT3 comes in those sizes too. Cheers

---

2.7s have 18s, will not fit 3.0 later cars as the brake calipers are massive and no amount of dressing the castings will allow LR 18s, unless you turn 2mm off of the rim inner and that'd weaken the rims, which are, by the way out of round