Thread: Catch can install on 2016 Discovery SDV6

I asked about fitting one feedback from installer ( not front desk) was it was bloody hard to do quite expensive and he hadn't seen much benefit on these engines. Blanking EGRs though everyone I've spoken to is in favor of this

Originally Posted by Meccles

I asked about fitting one feedback from installer ( not front desk) was it was bloody hard to do quite expensive and he hadn't seen much benefit on these engines. Blanking EGRs though everyone I've spoken to is in favor of this

I also looked at blanking the two ERGs out in my TDV6 as well, but apparently it's not as simple as it sounds either? through my research it was looking like you would need to buy EGV valve emulators to go on the end of the EGR valves for position feedback to the ECU? not a simple matter of blanking off and unplugging the units? the emulators i found were pretty expensive and took some finding.

Happy to be corrected though

I have however successfully, blanked off the EGR in my good old TD5 and that was pretty painless and worked really well.

Mine were done when ECU was re Programmed. But they cycle open on start up- it's illegal for tuners to have them permanently closed.