Thread: Self induced errors.

No issues this morning although i did notice that the LED on the SC80 wasn't lit at all ?

As your main battery was low, the SC80 would have disconnected the Aux. After you start your car and the main battery goes over 13.2V, the SC80 would connect them again and the LED would show solid green.

All good coming home so just a low soc of the main battery, I couldnt find anything that mentioned what the led not lit meant.

Is your earth lead from the traxide connected correctly. I have had my battery down to 10 volts and the light on the traxide was still on.


Just a thought - Tim would be best to ask.

Cheers Ean

Originally Posted by Ean Austral

Is your earth lead from the traxide connected correctly. I have had my battery down to 10 volts and the light on the traxide was still on.


Just a thought - Tim would be best to ask.

Cheers Ean

I believe so Ean, i did crimp another connector on it with a larger eye so will check it out.

Issue reappeared on the way home, coincidently maybe but my ds door switch is playing up and wouldnt go out along with the corresponding door open message on the dash.
I just measured both batteries, main on 13.1 and aux. on 13, and a correction on the LED it is on just not as bright as it is with engine running.

I think i have found the problem and i believe it is the door micro switch, this morning the interior light didnt come on when i opened the door and on the way home from dropping kids at school i ad the same HDC,handbrake and lowered suspenion error come on.
Got home and testing the door i still get door open, sprayed some wd40 in there so hope it may loosen the switch if only temporarily.
I believe that the switch is in the actuator so hoping some one can confirm that for me.

Originally Posted by loanrangie

I think i have found the problem and i believe it is the door micro switch, this morning the interior light didnt come on when i opened the door and on the way home from dropping kids at school i ad the same HDC,handbrake and lowered suspenion error come on.
Got home and testing the door i still get door open, spayed some wd40 in there so hope it may loosen the switch if only temporarily.
I believe that the switch is in the actuator so hoping some one can confirm that for me.

missing the simplicity of the D1 yet Nick?