Thread: brake sensor warning light

Hi,
brought and installed a new rear brake sensor for my disco 3 and i can not get rid of the warning light on the dash . I have read a lot of on line forms to find a resolution and have removed fuse even when i had new battery installed it didnt remove it. i have tried the turn engine on and off 10 times. Do any members have any ideas? I have also removed the cable and re installed

I have always held a love for landrover as my late father was a panel beater ( the old school) and i watched him replace the roof of a rolled range rover. He brought that car and i loved it, the shape and style . He brought an 87 disco and i was hooked, three series later and i experience everything from the three amigos, broken air suspension. but i a glutton for punishment and love my disco.



Discovery 1 -1987S car park attendant blew gear box
Discovery 2 2001 HSE v8 LOVE IT
Discovery 3 2008 SE- ( face lifted to look like super charge)

I suspect the wire is not connected correctly. I recently had the brakes done and sensors replaced on the D4 (now gone), but the one on the passenger side front wheel kept popping out. On the UK forums they say that aftermarket parts don't always fit as well, you need to push the connector in firmly (the one behind the wheel arch lining). The garage pushed it in once then a speed hump later it came out again. Then they pushed it in and taped it up, that seemed to hold it in place. I would have changed it for a LR part but as I traded in I left it.

Ron