Thread: What happened to your D3/D4 today?

Originally Posted by loanrangie

Dunlop wasn't factory fitted, its another aftermarket part which would be better than a cheap chinese knockoff.

I stand corrected Your Honour I knew AMK wasn't original but that's all I've known in mine but knew that the other two have been referenced on the forum.

Originally Posted by Narangga

I stand corrected Your Honour I knew AMK wasn't original but that's all I've known in mine but knew that the other two have been referenced on the forum.

AMK is original and fitted around 2012 after the hitachi factory was wiped out.

Originally Posted by loanrangie

AMK is original and fitted around 2012 after the hitachi factory was wiped out.

Thanks for that info. Vehicle plated 06/06, I purchased 09/15 and by 04/19 the desiccant was dry and there was no powdering to it. Solenoid/Centre Valve subsequently replaced in 06/23.

Getting ready to rebuild the front valve block and as i was jacking it up i heard air escaping, hand over the left strut and found the leak .
Going to need to find a used one to last me the next week while i order a new pair.

FB member was kind enough to give me a pair of good struts dated 08/08/2019 Delphi so over 12 years newer than mine and are a vast improvement, even compressing them to get the bottom bolt in took a jack.
Rear top bolt is a pain to access but the tin snips made it easier, I cut the sides of the alignment slot to open it up.
You can just see the socket thru the opening.

On my list of possible worries how serious is the risk of injector failure on a TDV6 that’s getting close to 300k kms? Do they give warning?

There’s quite a lot of discussion on Toyota injectors failing in the D4D and needing scheduled replacement to avoid engine destruction.

This morning my Disco came up and told me I had a service due in 3150km. It’s never done that before. At best it would just say service due. I guess when I last took it into the Indy they changed the service interval from time to KM based, which I think is much cooler. Hopefully that sticks when I reset it with my GAP tool.

Originally Posted by PerthDisco

On my list of possible worries how serious is the risk of injector failure on a TDV6 that’s getting close to 300k kms? Do they give warning?

There’s quite a lot of discussion on Toyota injectors failing in the D4D and needing scheduled replacement to avoid engine destruction.

I wouldn't personally worry, they are reasonably robust, I've not heard of engine failure because of it.

Toyota injectors are notorious for failure, some resulting engine failure.