Thread: Does anyone do rubber Defender-like mud flaps for a D4? <EOM>

I fitted Defender 90 rear mud flaps to the rear of my D4. I used genuine LR as they had the “Land Rover” logo. You need to remove the metal bracket and trim the rubber so it fits around the exhaust.

Discovery 1 fronts fit the front of a Discovery 4 without cutting, just need a couple of new holes for fixing screws. I wasn’t fussed about the ‘Mountain’ logo so didn’t use genuine parts.

Originally Posted by kelvo

Discovery 1 fronts fit the front of a Discovery 4 without cutting, just need a couple of new holes for fixing screws. I wasn’t fussed about the ‘Mountain’ logo so didn’t use genuine parts.

Kelvo do you reckon the D1 fronts would also fit on the rear?

2 pairs of eBay Defender / County mud flaps @ $35/pair, and some Land Rover decals also from eBay

Originally Posted by BrianElloy

Kelvo do you reckon the D1 fronts would also fit on the rear?

They would fit, but would be too small IMHO. The D1 fronts are only 240mm wide, the Defender 90 rears are 360mm wide.

Plenty of discussion here a few years ago.

D4 Mudflaps

You will find my fitting 3-4 pages in. Mine are still going strong.
Cheers,

Originally Posted by cjc_td5

Plenty of discussion here a few years ago.

D4 Mudflaps

You will find my fitting 3-4 pages in. Mine are still going strong.
Cheers,

I went with the advice from the thread & fitted D1 & Defender flaps, front & rear respectively. 4 years now & still going strong.

I did the same and they’re just right. Rears have the logo on and the fronts are smaller but adequate for the job. Got them from Rimmer in the UK from memory. Not expensive and good delivery time.
I also have chains to hold them up if we go through sand but just leave them attached ‘cos I’m too lazy to disconnect them. 😀
AlanH.