Thread: Restricted Performance with no fault codes

Looking for some advice, started getting the restricted performance message whilst driving the other day no extreme loads just city traffic.

Plugged in the Gap iid tool no faults showing

Read some posts so took off the engine cover had someone load up the engine no leaks or sparky that I can see.

Tried a reset by disconnecting the battery fault cleared, as it does turning the car off for 1/2 hr however appears again within a couple of minutes doing less than 60 with no load. Still no faults registering on the Gap tool

If there was a fault registered on the Gap tool at least I could pinpoint the issue

Thanks in advance

Discojeffster
I will have a look this re pending codes.

There were some fault codes that come up, however none I felt were related to restricted performance