Thread: Drilling into D3 engine bay

Originally Posted by John_D4

Did you end up buying a kit or just use a bolt and not to seat them?

Had 4 x M8 rivnuts to do. I used diy tool (nut and bolt) for one of them. Was faster to do the other three with the proper tool. Bought on ebay and came with 60 rivnuts for $42.

Will definitely use rivnuts again so was a good investment and saved a lot of time.

Originally Posted by DiscoJeffster

Have been using them for over 25 years. Best thing ever, after electronic fuel injection

Only them once but about to buy myself a set.