Thread: EAS Calibration - Not Sure if I should...

Originally Posted by PeterOZ

all sorted, rear end has nice new arms and hub bushes, did the height calibration. Interestingly it did not wat to work with guided mode at first, started using manual then went back to guided and it worked. Wheel align done front and rear and it drives very nicely again.

Next jobs for me to do are transmission flush and filter
EGR blank and SW patch.
clean out the inlet Y & remove butterfly
Flush and new fluid for the power steering.

My guided gets angry when I'm out of the car. I leave my kids in it now and tell them up and down to get it done. Not sure if it's interference or what

Originally Posted by josh.huber

My guided gets angry when I'm out of the car. I leave my kids in it now and tell them up and down to get it done. Not sure if it's interference or what

Yeah I think the Bluetooth signal gets a bit sketchy outside the vehicle. I lean my phone against the drivers window and then do it from there, wandering around the vehicle measuring and adjusting

Originally Posted by DiscoJeffster

Yeah I think the Bluetooth signal gets a bit sketchy outside the vehicle. I lean my phone against the drivers window and then do it from there, wandering around the vehicle measuring and adjusting

That's weird. I use both my phone and iPad to talk to the iid from outside the vehicle routinely. Even from behind the van sometimes.