Reply With QuoteGet a D4 receiver (Part number LR040248) and any square hitch tongue and ball will slot in.
The receivers come up here from time to time. I bought mine new from the UK as mine came with the UK towball and it hangs way too low for my van.
Wizard
Mate has a new (to him) D3. Some scumbag took the whole tow ball and tow hitch from the vehicle when it was in the previous owners hands.
He would like to re-install said items to his vehicle.
Can anyone give me an idea as to what he needs. He cant afford a mitch hitch,just the basic one will do him for now.
Have downloaded the D3 workshop manual (thanks Incisor) but that only shows the UK variant.
Do we have a different setup or is it the same as UK vehicles.
Thanks
DG
2014 Freelander SE TD4
2003 Range Rover TD6
92 disco tdi manual sold
95 disco tdi auto gone
Super ModeratorGet a D4 receiver (Part number LR040248) and any square hitch tongue and ball will slot in.
The receivers come up here from time to time. I bought mine new from the UK as mine came with the UK towball and it hangs way too low for my van.
MY08 D3 - The Antichrist - "Permagrimace". Turn the key and play the "will it get me home again" lottery.
Master
SupporterYep, as above.Originally Posted by BradC
I just bought a D3 and it came with the D3 receiver which tucks back under the spare wheel and needs removing to lower the spare (so I keep reading, and looks like it too), so forget about that and get matey mate to buy a D4 version which does not snag the spare, so no unhitching the trailer to change tyres, it will fit up into the D3 without issue and accepts any standard 50mm square hitch.
I looked a few days ago and there were a couple of D4 versions around the 200 mark.
Also when mine is locked in correctly there is zero play, receiver and vehicle are as if welded together, I read that ppl have had theirs drop out but I fitted and refitted a number of times and managed to sometimes 'lock' it in with the lever flicked back and sitting correctly but there would be a couple mm if that of play so not seated 100% even though I could not pull it down by stomping on it, but the dynamics with a trailer jiggling on it would be more stressful, so I think it is a case of 99% sitting there is not good enough it needs to be 100% firm on the vehicle.
Super ModeratorThere was a recall years ago, and somewhere on the net there is an LR document that explains the "how to check" bits. I check by 2 marks I've made on the handle and poking my finger up the back to double check the engagement every time I put it in.
Essentially, when not towing take it out. If you don't, it'll either rattle and wear or rust in place. Mine goes in before I hook up the van and comes out when I unhitch. Sits in the annexe while we're away. Then again, I also clean & grease both parts and put the dust cover in when the hitch comes out.
Look after it, follow the instructions and don't smack it on a rock while 4wd'ing and you'll be fine.
MY08 D3 - The Antichrist - "Permagrimace". Turn the key and play the "will it get me home again" lottery.
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks