Results 1 to 3 of 3

Thread: Dedicated Pump bracket and power take off

  1. 23rd December 2007, 10:03 PM #1
    RichardK
    RichardK is offline ChatterBox Silver Subscriber
    Join Date
    Jan 1970
    Location
    Western Australia
    Posts
    2,955
    Total Downloaded
    0

    Dedicated Pump bracket and power take off

    It has been some time in development but I have finally succeeded in developing a kit for mounting my dedicated hydraulic pump for my hydraulic winch and a power take off point for it.

    The power take off is via v belt as there is little room available for a flat belt drive.

    I will mount the pump in the next couple of days and connect the winch, I believe it could be a world first

    Some pics.......





    The Complete Kit



    Platform in position





    Drive take off
    RichardK

    Series IV Matrix Offroad Camper following our Discovery 3 with E Diff, BAS Remap, Mitch Hitch, Uniden UHF, Codan NGT HF, Masten TPMS, Proquip Compressor Guard, ARB Winch Bar, Milemarker Hydraulic Winch, 4x4 Intelligence Rear Wheel Carrier, VMS GPS with Rear Camera,
    Reply With Quote Reply With Quote
  2. 25th December 2007, 09:23 PM #2
    LandyAndy's Avatar
    LandyAndy
    LandyAndy is offline RoverLord Gold Subscriber
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    Not often I poke my nose in here,being a mere D2 and lower pilot
    Richard you are a genius,I would be deleting the pics getting the bits fabricated professionally and tipping the vast returns into your retirement fund.
    WELL DONE MATE!!!!!!
    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post
    Reply With Quote Reply With Quote
  3. 25th December 2007, 10:13 PM #3
    RichardK
    RichardK is offline ChatterBox Silver Subscriber
    Join Date
    Jan 1970
    Location
    Western Australia
    Posts
    2,955
    Total Downloaded
    0
    Hello Andy, Merry Xmas mate.

    They have been professionally made, laser cut, machine bent powder coated, unfortunately I don't see a fortune in it, too few hydraulic winches are in use in Oz and D3's would be a minute amount, I may be the only one. However the UK, Europe and the US may be different where the Milemarker is well accepted, I have already sent a kit off for evaluation to the UK and apart from some minor mods I think it should fill a gap for them.
    RichardK

    Series IV Matrix Offroad Camper following our Discovery 3 with E Diff, BAS Remap, Mitch Hitch, Uniden UHF, Codan NGT HF, Masten TPMS, Proquip Compressor Guard, ARB Winch Bar, Milemarker Hydraulic Winch, 4x4 Intelligence Rear Wheel Carrier, VMS GPS with Rear Camera,
    Reply With Quote Reply With Quote
« Workshop Manual? | Series 3 Dakar »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!