Thread: Car kit install - Power source and audio mute

Hi WhiteD3,
I did 2 of these this week so i can give u some useful info.
Power can be taken from the headlight switch to the right of your steering wheel. Just pull this section off using firm but gentle tugging. You may/maynot break a clip, but can be replaced easily from spares.
Grab from the corner of the panel that incorporated the air vent as it comes away as one unit.
+ve power supply (red) is connected to the Brown/Green wire
Ignition switch (blue) is connected to the Brown/purple wire(the thinner one!) & earth is connected to the black wire.
The yellow wire for the mute goes to the rear of the stereo in Pin 10 of the smaller plug. You will know what i mean when u remove the head unit.
Pin 10 is blank & does not have a wire coming from it. You will have to find a terminal to fit into the plug that then plugs back into the stereo.
This will trigger the mute when an incoming call is registered & on the stereo will say phone mute from memory.
Anymore help required dont hesitate to ask.
Cheers.
p.s. the button i normally fit above the internal air temp sensor on the L/h/s of the s/wheel. On the section where the light switch would go.

Thanks Sniegy, I'll go and have a look right now

Sniegy, Is the power from the light switch permanant or or igition on only?

Originally Posted by CaverD3

Sniegy, Is the power from the light switch permanent or or ignition on only?

CaverD3, Brown/Green is permanent, brown/purple is ignition.

Thanks Sniegy, all installed and going. It was certainly easier than trying to get to the cig lighters!

Thanks guys, the permanent one there is easier than the glove box one to get to.

Sniegy,

Is there any way to get the phone audio to go through the stereo?