Results 1 to 4 of 4

Thread: wireless reverse camera

  1. #1
    Join Date
    May 2008
    Posts
    100
    Total Downloaded
    0

    wireless reverse camera

    anyone installed a wireless camera on your d3?, i got a no name brand gps with wireless camera, a bit unsure best way to install the wireless camera, not really wireless as you need to hook up the wire from the camera to the reverse light wire for it to be powered up and send signal. thanks

  2. #2
    Join Date
    Mar 2008
    Location
    Sydney, Australia
    Posts
    2,351
    Total Downloaded
    0
    You can stick the camera in the gap for the trailer sockets and there is a grommet behind the RLH tail light cluster to connect to the reversing light. Make sure you tie the wire out of the way so it doen't get tangled in the D3s steel balls.

  3. #3
    Join Date
    Dec 2009
    Location
    Sydney
    Posts
    523
    Total Downloaded
    0

    Any more experience?

    I did a forum search and found this old thread...

    Anyone else have any experience about where to mount the monitor for an aftermarket reverse camera?

    Cheers,

  4. #4
    Join Date
    Apr 2008
    Location
    Cardup, West Aust
    Posts
    227
    Total Downloaded
    0
    Sheckster,

    I have installed a wired reversing camera. As noted in post above, you will still need to connect to reverse light to activate the camera.

    I mounted the camera on the bottom of the "handle" on the top rear door, to the right hand side. I ran the cables up behind the cover on the inside of the windown and then through the conduit that the other cables run into the roof. All the covers just pull off by hand, although you need to be firm. The only part I had to unscrew was the "handle" on the outside of the door to run the cable through.

    I connected the leads up fairly close to the terminals that connect to the lights. This made it easier to ensure had the correct wires, as they are all bundled into a conduit before they pass through the grommet into the vehicle.

    The only issue with where I have mounted it is that it does not point directly behind but at a slight angle. I have a Michell Bros hitch which makes it hard to mount something out of the way on the bumper. I am not too worried about this as I have my spare on a rear wheel carrier that is in the way, but I can can some view of what is behind the spare.

    Hope this is of some use to you. Good luck.
    Last edited by Brick; 7th January 2010 at 07:15 PM. Reason: clarity
    Cameron
    If in doubt, throttle out
    MY16 RRS SE SDv6
    MY16 Ranger XLT
    2008 911 GT2 - dream came true
    1976 Escort mk2 - race car

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!