Im stuck in Brisy while the wife pinched my Rangy to go visiting friends. So googleing around i found this lovely rear end set up. If i was back in WA i could get my local Sheet metal guy to knock this up from my drawings. Anyone on the forum own a metal shop with a press & guilo. Or is there a good fabricator that could put this together at a reasonable price.
7 points for ingenuity, but each to his own, I guess.
Quite an overhang? and quite a load on such short pivot(s).
If this car went "as bush" as the setup depicts, i think the tailgate and window could be/look a bit vunerable to a little nudge rearward to a tree, bank or such?
The trailer would have to stay at home.
Master
Posting Permissions
Reply With Quote
Bookmarks