Thread: Rear storage

Originally Posted by landie56

How's anyone put in titan draws or made your own. Can you please put some pictures of your draws.

Thanks landie56
RR L322 owner

I’d also be keen to see this as I also have been contemplating rear draws. Had Ron’s draws in my P38 but sold them with the car...should have kept them for the L322

THe problem with rear drawers how do you access your spare tyre without removing the drawers every time?

I would have the spare mounted on the roof cage if I was going on a trip. Would love a swing away tyre carrier

Originally Posted by Steinzy

Had Ron’s draws in my P38 but sold them with the car...should have kept them for the L322

Hey! I wanted them back!

I have these Chuckwagon drawers in mine (they have been fitted in a Disco 1, a Defender, my P38A, and now the L322). They only go in for trips away. The spare wheel goes on the roof rack. My fridge is strapped in behind the front left seat. The rear 2/3rd seat is just folded up. You can see it in the 3rd photo.

The drawers are bolted to Unistrut rails which are, in turn, bolted to the positions where the tie-down rings are normally fitted.

I have two AGM Deep Cycle batteries fitted under the floor on the RHS in the well under the fuse panel.


L322 Drawers 1.jpg L322 Unistrut rails 2.jpg L322 Unistrut rails.jpg

In the P38A (the narrower shelf was from when it was in a 110):

Chuckwagon Drawers 1.jpg

Great work Ron

I take the boxes and the drawer out of the frame and can lift it in. It slides easily into position on the Unistrut and just needs a little wriggling to line up the bolts. I leave the floor out of the boot and have a filler piece at the very rear. It lifts out to give access to very large storage compartment made available when the spare wheel is removed. If needs be, I can remove the drawer or the lower plastic crate to get even easier access.

Almost ready to go. The tyre is strapped on with a Y-strap.

L322 Roof Rack loaded.jpg

Originally Posted by p38arover

Hey! I wanted them back!

I have these Chuckwagon drawers in mine (they have been fitted in a Disco 1, a Defender, my P38A, and now the L322). They only go in for trips away. The spare wheel goes on the roof rack. My fridge is strapped in behind the front left seat. The rear 2/3rd seat is just folded up. You can see it in the 3rd photo.

The drawers are bolted to Unistrut rails which are, in turn, bolted to the positions where the tie-down rings are normally fitted.

I have two AGM Deep Cycle batteries fitted under the floor on the RHS in the well under the fuse panel.


L322 Drawers 1.jpg L322 Unistrut rails 2.jpg L322 Unistrut rails.jpg

In the P38A (the narrower shelf was from when it was in a 110):

Chuckwagon Drawers 1.jpg

Like the simple way. K.i.s principal.

I have put the Prado Titan Draws in to my D3 using turnbuckles to secure them to the existing tiedown points. I did need to rivet loop brackets to the sides of the draws but these are holding up fine. I can send pickture if required but is quite easy. You may need a plyboard under the draws to stop them rubbing on tailgate when open.