Results 1 to 3 of 3

Thread: Wheel alignment suspension set

  1. 30th October 2018, 06:56 AM #1
    theelms66's Avatar
    theelms66
    theelms66 is offline Master Supporter
    Join Date
    Dec 2017
    Location
    wandin nth vic
    Posts
    497
    Total Downloaded
    0

    Wheel alignment suspension set

    Since the gap tool doesn't seem to have a tight tolerance set for the l322 -03 can i use the transport mode setting? Or just leave the drivers door open whilst adjustments are carried out.
    TIA

    PAS
    Reply With Quote Reply With Quote
  2. 31st October 2018, 09:18 PM #2
    Roverlord off road spares
    Roverlord off road spares is offline AT REST
    Major part of the heart and soul of AULRO.com
     Vendor

    Subscriber
    Join Date
    Jul 2012
    Location
    Tecoma Vic
    Posts
    9,642
    Total Downloaded
    0
    Pas, I had mine done by wide tread in FTG took ages, found out the guy doing it had to keep motor running and got hot from the exhaust all the time.
    I thought if you pull the compressor relay in the boot it would stop the height changing or use iidtool to disable EAS , but i could be wrong

    Reply With Quote Reply With Quote
  3. 31st October 2018, 10:21 PM #3
    theelms66's Avatar
    theelms66
    theelms66 is offline Master Supporter
    Join Date
    Dec 2017
    Location
    wandin nth vic
    Posts
    497
    Total Downloaded
    0
    Thanks mario. I told them to leave the drivers door open to stop any adjustments of the eas .all good .Toe was almost 11.mm out after bush replacement. Also aligned rear.
    Reply With Quote Reply With Quote
« 2007 TDV8 front air strut tear down | 2010 SC missing trailer brake connector behind dash »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!