Thread: Traxide in cab module

Hi, 2011 L322 4.4TDV8, trying to find out instructions for the In cab module switch with led light, watched end of video of install and Tim said full instructions of module would be in next video which he never made, install instructions have nothing either, am about to head off for an 11,000 klm trip to WA towing caravan running a fridge in the back and an inverter for our starlink and want to isolate start battery, even though start battery is in good working order (been checked) still getting low battery warning, have ordered led interior lights which will help, also jump starting main from aux batteries they both share a common ground so I just need a lead long enough which will run from front to back to jump start. I have a 120w solar on roof hooked up to aux through a regulator so I should be good with car being out of garage for next two months

Hi again Mjak42 and just a suggestion.

Instead of getting one very long jumper lead, to go from the rear cargo area to the cranking battery, try fitting a short led and a Marine Battery Switch.

Run a cable from the point where the Traxide cable bolts to the centre of the L322s fuse panel to the Auxiliary Battery's Positive ( + ) terminal and then fit the Marine Battery Switch into this new cable.

Simply leave the Marine Battery Switch off except if you need to jump start.

Turn the switch on in the rear cargo area and then go to the cab and try starting your motor.

Just remember to turn the switch off once the motor is running.

Also another suggestion, if you are getting Low Battery warnings, try the following in the link below.

Scroll down the page till you get to “Battery Maintenance”
https://www.aulro.com/afvb/the-verandah/246755-line-auto-electrical-info-8.html