Australian Land Rover Owners

Section Widget
Travel

Overseas

Overseas

Technical
Categories Widget (Show All)
Recent Articles

incisor

There is no available content written by incisor

Recent Article Comments Widget
Recent Blog Posts
Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

When I did mine(TD5) I used Lokseal as a very medium threadlock.
I don't know how hard or easy to remove medium strength loctites are, but I do
AK83 5th April 2026, 06:40 AM

What happened to your Discovery 2 today?

I spent pretty much all day on it yesterday.

Wheelbase turned out to be 2543mm RHS and 2435 LHS ... 8mm difference.
I worked out that
AK83 5th April 2026, 06:20 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

How easy/hard are the exhaust manifold studs to remove later if needed? Do you have to heat them up?
Max Headroom 2.3m 5th April 2026, 02:14 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

If the studs dont have a listed spec, use the torque for the nuts using either the double nut or a stud setting tool.

in the real world...
Blknight.aus 5th April 2026, 01:03 AM

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Be careful using anti-seize on nuts. This will change the nut factor ('K' factor) of the torque specification. The specified torque of 25Nm was predicated
Max Headroom 2.3m 4th April 2026, 11:59 PM

Search AULRO.com ONLY!	Search All the Web!

All times are GMT +10. The time now is 07:13 AM.

AULRO.com
Copyright 2001 - 2026
Independently Owned and Operated by
Dave Blears Computing - DavecandoIT - AULRO.com
LAND ROVER and its logo are the registered trademarks of Land Rover.
Land Rover is not affiliated with AULRO.com.

Section Widget

Categories Widget (Show All)

Recent Articles

incisor

Recent Article Comments Widget

Recent Blog Posts

Recent Forum Posts

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

What happened to your Discovery 2 today?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?

Correct Procedure to Fit Exhaust Manifold/Turbo Studs?